Fischer Resistud Threaded Rod

• Threaded rods are supplied with an easy to use hexagonal installation drive or can be installed with an adapter.
• High-performance resin guarantees high loads in non-cracked concrete.
• The resin anchoring is free of expansion forces and permits small axial spacings and edge distances.
• Wide range for many applications.

For fixing of:

• Steel constructions
• Railings
• Consoles
• Ladders
• Cable trays
• Machines
• Staircases
• Gates
• Facades
• High racks
• Stand-off installations
• Wooden constructions
   

Fischer Cone Drill and Sleeve

Description:

• Centring sleeve and cone drill bit specially for use with Injection mortars FIS V, FIS VS, FIS VT and FIS P in aircrete.
• The special undercut drill bit PBB produces a conical drill-hole in aircrete.
• The centring sleeve fixes the threaded rod in the drilled hole and allows overhead installation.
• The injection mortar anchors by means of undercut technology in the conical hole. This provides better distribution of forces in aircrete than in cylindrical drill holes.
• Can be used with Threaded rods FIS A.
• Threaded rod FIS A made of A4 stainless steel for outdoor use and in damp conditions.

Advantages/Benefits

• Undercut technology of the mortar guarantees high loads in aerated cement.
• Sturdy, long-life drill bit for high cost-efficiency.
• Two adjustable drilling depths increase flexibility on site (e.g. higher loads, plaster covering).
• Small drill diameter enables economical use of mortar.

Approved for:

• Block- and plan bricks
• Roof- and ceiling tiles made of aerated cement

For fixing of:

• Facade and roof substructures made of wood and metal
• Canopies
• Gratings
• Hand-rails
• Consoles
• Pipelines
• Sanitary equipment
• Suspended ceilings
• Cable trays
• Steel and wooden constructions in general

Approval: German approval (DIBt) for aerated cement in conjunction with Injection mortar FIS V, Cone drill PBB, Centring sleeve PBZ and threaded rod FIS A.